Mouse LRP1 ELISA Kit (MOFI00526)- High Sensitivity

Product Name:	Mouse LRP1 ELISA Kit
Product Code:	MOFI00526
Size:	96 Assays
Alias:	Lrp1, LRP1, Prolow-density lipoprotein receptor-related protein 1, LRP-1, Alpha-2-macroglobulin receptor, A2MR, Apolipoprotein E receptor, APOER, CD91
Detection Method:	Sandwich ELISA
Application:	This immunoassay kit allows for the in vitro quantitative determination of Mouse Lrp1 concentrations in serum plasma and other biological fluids.
Sensitivity:	0.094ng/ml
Range:	0.156-10ng/ml
Storage:	4°C for 6 months
Note:	For Research Use Only

Recovery:

Matrices listed below were spiked with certain level of Mouse Lrp1 and the recovery rates were calculated by comparing the measured value to the expected amount of Mouse Lrp1 in samples.

Matrix	Recovery range(%)	Average(%)
serum(n=5)	88-105	95
EDTA plasma(n=5)	93-99	96
UFH plasma(n=5)	86-102	96

Linearity:

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Mouse Lrp1 and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample	1:2	1:4	1:8
serum(n=5)	88-104%	86-100%	88-99%
EDTA plasma(n=5)	85-94%	87-97%	89-98%
UFH plasma(n=5)	84-100%	82-100%	80-98%

Intra Assay:

CV <8%

Inter Assay:

CV <10%

Component	Quantity	Storage
ELISA Microplate (Dismountable)	8-12 strips	4°C for 6 months
Lyophilized Standard	2	4°C/-20°C
Sample/Standard Dilution Buffer	20ml	4°C
Biotin-labeled Antibody(Concentrated)	120ul	4°C (Protect from light)
Antibody Dilution Buffer	10ml	4°C
HRP-Streptavidin Conjugate(SABC)	120ul	4°C (Protect from light)
SABC Dilution Buffer	10ml	4°C
TMB Substrate	10ml	4°C (Protect from light)
Stop Solution	10ml	4°C
Wash Buffer(25X)	30ml	4°C
Plate Sealer	5	-

Other materials and equipment required:

Microplate reader with 450 nm wavelength filter
Multichannel Pipette, Pipette, microcentrifuge tubes and disposable pipette tips
Incubator
Deionized or distilled water
Absorbent paper
Buffer resevoir

Uniprot

Q91ZX7

UniProt Protein Function:	LRP1: a receptor involved in endocytosis, phagocytosis of apoptotic cells, and neural signaling. Modulates cellular events including APP metabolism, kinase-dependent intracellular signaling, neuronal calcium signaling and neurotransmission. Involved in the plasma clearance of chylomicron remnants and activated alpha 2-macroglobulin, as well as the local metabolism of complexes between plasminogen activators and their endogenous inhibitors. Plays a fundamental role in cellular signaling pathways in the brain. Mediates neural NMDA gating via a complex of LRP1, PSD-95 and NMDAR. A type I membrane protein. After cleavage, the intracellular domain (LRPICD) is detected both in the cytoplasm and in the nucleus. Most abundant in liver, brain and lung.
UniProt Protein Details:	Protein type:Cell surface; Membrane protein, integral; Motility/polarity/chemotaxis; Receptor, misc. Chromosomal Location of Human Ortholog: 10\|10 D3 Cellular Component: basolateral plasma membrane; cell soma; clathrin-coated pit; clathrin-coated vesicle; cytoplasm; cytosol; dendrite; early endosome; endosome; focal adhesion; integral component of membrane; integral component of plasma membrane; lysosomal membrane; membrane; nucleolus; nucleus; perinuclear region of cytoplasm; plasma membrane; receptor complex Molecular Function:alpha-2 macroglobulin receptor activity; apolipoprotein binding; calcium ion binding; clathrin heavy chain binding; metal ion binding; protease binding; protein binding; protein complex binding; RNA binding Biological Process: apoptotic cell clearance; astrocyte activation during immune response; cardiac septum development; cell proliferation; cellular response to amyloid-beta; cholesterol metabolic process; endocytosis; multicellular organism development; negative regulation of neuron apoptosis; negative regulation of neuron projection development; negative regulation of platelet-derived growth factor receptor-beta signaling pathway; negative regulation of smooth muscle cell migration; negative regulation of Wnt signaling pathway; positive regulation of amyloid-beta clearance; positive regulation of cell death; positive regulation of cholesterol efflux; positive regulation of endocytosis; positive regulation of lipid transport; positive regulation of lysosomal protein catabolic process; positive regulation of protein binding; positive regulation of protein catabolic process; positive regulation of protein transport; protein kinase C-activating G-protein coupled receptor signaling pathway; receptor-mediated endocytosis; regulation of actin cytoskeleton organization; regulation of cholesterol transport; regulation of phospholipase A2 activity; regulation of protein metabolic process; transcytosis
UniProt Code:	Q91ZX7
NCBI GenInfo Identifier:	124494256
NCBI Gene ID:	16971
NCBI Accession:	NP_032538.2
UniProt Secondary Accession:	Q91ZX7,Q61291, Q920Y4,
UniProt Related Accession:	Q91ZX7
Molecular Weight:	504,742 Da
NCBI Full Name:	prolow-density lipoprotein receptor-related protein 1
NCBI Synonym Full Names:	low density lipoprotein receptor-related protein 1
NCBI Official Symbol:	Lrp1
NCBI Official Synonym Symbols:	Lrp; A2mr; CD91; AI316852; b2b1554Clo
NCBI Protein Information:	prolow-density lipoprotein receptor-related protein 1
UniProt Protein Name:	Prolow-density lipoprotein receptor-related protein 1
UniProt Synonym Protein Names:	Alpha-2-macroglobulin receptor; A2MR
Protein Family:	Low-density lipoprotein receptor-related protein
UniProt Gene Name:	Lrp1

*Note: Protocols are specific to each batch/lot. For the correct instructions please follow the protocol included in your kit.

Step	Procedure
1.	Set standard, test sample and control (zero) wells on the pre-coated plate respectively, and then, record their positions. It is recommended to measure each standard and sample in duplicate. Wash plate 2 times before adding standard, sample and control (zero) wells!
2.	Aliquot 0.1ml standard solutions into the standard wells.
3.	Add 0.1 ml of Sample / Standard dilution buffer into the control (zero) well.
4.	Add 0.1 ml of properly diluted sample (Human serum, plasma, tissue homogenates and other biological fluids.) into test sample wells.
5.	Seal the plate with a cover and incubate at 37 °C for 90 min.
6.	Remove the cover and discard the plate content, clap the plate on the absorbent filter papers or other absorbent material. Do NOT let the wells completely dry at any time. Wash plate X2.
7.	Add 0.1 ml of Biotin- detection antibody working solution into the above wells (standard, test sample & zero wells). Add the solution at the bottom of each well without touching the side wall.
8.	Seal the plate with a cover and incubate at 37°C for 60 min.
9.	Remove the cover, and wash plate 3 times with Wash buffer. Let wash buffer rest in wells for 1 min between each wash.
10.	Add 0.1 ml of SABC working solution into each well, cover the plate and incubate at 37°C for 30 min.
11.	Remove the cover and wash plate 5 times with Wash buffer, and each time let the wash buffer stay in the wells for 1-2 min.
12.	Add 90 µL of TMB substrate into each well, cover the plate and incubate at 37°C in dark within 10-20 min. (Note: This incubation time is for reference use only, the optimal time should be determined by end user.) And the shades of blue can be seen in the first 3-4 wells (with most concentrated standard solutions), the other wells show no obvious color.
13.	Add 50 µL of Stop solution into each well and mix thoroughly. The color changes into yellow immediately.
14.	Read the O.D. absorbance at 450 nm in a microplate reader immediately after adding the stop solution.

When carrying out an ELISA assay it is important to prepare your samples in order to achieve the best possible results. Below we have a list of procedures for the preparation of samples for different sample types.

Sample Type	Protocol
Serum:	If using serum separator tubes, allow samples to clot for 30 minutes at room temperature. Centrifuge for 10 minutes at 1,000x g. Collect the serum fraction and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles. If serum separator tubes are not being used, allow samples to clot overnight at 2-8°C. Centrifuge for 10 minutes at 1,000x g. Remove serum and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles.
Plasma:	Collect plasma using EDTA or heparin as an anticoagulant. Centrifuge samples at 4°C for 15 mins at 1000 - g within 30 mins of collection. Collect the plasma fraction and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles. Note: Over haemolysed samples are not suitable for use with this kit.
Urine & Cerebrospinal Fluid:	Collect the urine (mid-stream) in a sterile container, centrifuge for 20 mins at 2000-3000 rpm. Remove supernatant and assay immediately. If any precipitation is detected, repeat the centrifugation step. A similar protocol can be used for cerebrospinal fluid.
Cell culture supernatant:	Collect the cell culture media by pipette, followed by centrifugation at 4°C for 20 mins at 1500 rpm. Collect the clear supernatant and assay immediately.
Cell lysates:	Solubilize cells in lysis buffer and allow to sit on ice for 30 minutes. Centrifuge tubes at 14,000 x g for 5 minutes to remove insoluble material. Aliquot the supernatant into a new tube and discard the remaining whole cell extract. Quantify total protein concentration using a total protein assay. Assay immediately or aliquot and store at ≤ -20°C.
Tissue homogenates:	The preparation of tissue homogenates will vary depending upon tissue type. Rinse tissue with 1X PBS to remove excess blood & homogenize in 20ml of 1X PBS (including protease inhibitors) and store overnight at ≤ -20°C. Two freeze-thaw cycles are required to break the cell membranes. To further disrupt the cell membranes you can sonicate the samples. Centrifuge homogenates for 5 mins at 5000xg. Remove the supernatant and assay immediately or aliquot and store at -20°C or -80°C.
Tissue lysates:	Rinse tissue with PBS, cut into 1-2 mm pieces, and homogenize with a tissue homogenizer in PBS. Add an equal volume of RIPA buffer containing protease inhibitors and lyse tissues at room temperature for 30 minutes with gentle agitation. Centrifuge to remove debris. Quantify total protein concentration using a total protein assay. Assay immediately or aliquot and store at ≤ -20 °C.
Breast Milk:	Collect milk samples and centrifuge at 10,000 x g for 60 min at 4°C. Aliquot the supernatant and assay. For long term use, store samples at -80°C. Minimize freeze/thaw cycles.

Mouse LRP1 ELISA Kit (MOFI00526)

Description