Human Prohibitin/PHB1 ELISA Kit- High Sensitivity

Product Name:	Human Prohibitin / PHB1 ELISA Kit
Product Code:	HUFI02736
Size:	96 Assays
Alias:	PHB, PHB1, prohibitin
Detection method:	Sandwich ELISA, Double Antibody
Application:	This immunoassay kit allows for the in vitro quantitative determination of Human PHB concentrations in serum plasma and other biological fluids.
Sensitivity:	0.188ng/ml
Range:	0.313-20ng/ml
Storage:	4°C for 6 months
Note:	For Research Use Only

Recovery:

Matrices listed below were spiked with certain level of Human PHB and the recovery rates were calculated by comparing the measured value to the expected amount of Human PHB in samples.

Matrix	Recovery range(%)	Average(%)
serum(n=5)	87-102	93
EDTA plasma(n=5)	86-102	96
UFH plasma(n=5)	90-104	97

Linearity:

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Human PHB and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample	1:2	1:4	1:8
serum(n=5)	86-105%	85-104%	86-101%
EDTA plasma(n=5)	82-98%	82-101%	85-101%
UFH plasma(n=5)	83-100%	80-86%	84-95%

CV(%):

Intra-Assay: CV<8%
Inter-Assay: CV<10%

Component	Quantity	Storage
ELISA Microplate (Dismountable)	8×12 strips	4°C for 6 months
Lyophilized Standard	2	4°C/-20°C
Sample/Standard Dilution Buffer	20ml	4°C
Biotin-labeled Antibody(Concentrated)	120ul	4°C (Protect from light)
Antibody Dilution Buffer	10ml	4°C
HRP-Streptavidin Conjugate(SABC)	120ul	4°C (Protect from light)
SABC Dilution Buffer	10ml	4°C
TMB Substrate	10ml	4°C (Protect from light)
Stop Solution	10ml	4°C
Wash Buffer(25X)	30ml	4°C
Plate Sealer	5	-

Other materials and equipment required:

Microplate reader with 450 nm wavelength filter
Multichannel Pipette, Pipette, microcentrifuge tubes and disposable pipette tips
Incubator
Deionized or distilled water
Absorbent paper
Buffer resevoir

Uniprot

P35232

UniProt Protein Function:	PHB: a pleiotropic membrane protein that suppresses cell proliferation, apoptosis and senescence. It plays a role both in maintaining mitochondrial integrity and in cell cycle regulation. Expression increases approximately 3-fold upon entry into G1 phase compared with other phases of the cell cycle. It helps prevent ROS-induced senescence and its expression decreases heterogeneously during cellular aging. Helps maintain the angiogenic capacity of endothelial cells. Up-regulated during activation of primary human T cells via CD3/CD28 pathways. Present in multiple cellular compartments. Large assemblies of PHB and PHB2 localize in the inner membrane of mitochondria. Acts as a mitochondrial chaperone protein, regulates mitochondrial morphogenesis, and helps regulate the organization of mitochondrial DNA. Reported to target lipid rafts. In the nucleus, it has been reported to interact with various transcription factors, modulating their activity. A potential tumor suppressor that functions as a potent transcriptional corepressor for estrogen receptor alpha. It is downregulated by androgens, and represses androgen receptor activity. Co-localizes with Rb in the nucleus and recruits N-CoR and HDAC1 for transcriptional repression. In vivo promoter occupancy studies have suggested that the PHB gene is a direct target of c-Myc. May bind to and enhance the transcriptional activity of p53. Both Phb and Phb2 are present in the circulation and can be internalized by cultured cells. Overexpressed in endometrioid ovarian adenocarcinoma and papillary serous ovarian carcinoma. Mutated in sporadic breast cancer.
UniProt Protein Details:	Protein type:Oncoprotein; Cell cycle regulation; Mitochondrial; Chaperone; Motility/polarity/chemotaxis; Transcription, coactivator/corepressor; Nuclear receptor co-regulator; Apoptosis Chromosomal Location of Human Ortholog: 17q21 Cellular Component: nucleoplasm; membrane; mitochondrion; integral to plasma membrane; mitochondrial inner membrane; cytoplasm; nucleus Molecular Function:protein binding; enzyme binding; histone deacetylase binding Biological Process: osteoblast differentiation; regulation of apoptosis; transcription from RNA polymerase II promoter; negative regulation of cell proliferation; progesterone receptor signaling pathway; regulation of transcription, DNA-dependent; positive regulation of transcription, DNA-dependent; histone deacetylation; negative regulation of cell growth; negative regulation of transcription from RNA polymerase II promoter; signal transduction; negative regulation of transcription, DNA-dependent Disease: Breast Cancer
NCBI Summary:	This gene is evolutionarily conserved, and its product is proposed to play a role in human cellular senescence and tumor suppression. Antiproliferative activity is reported to be localized to the 3' UTR, which is proposed to function as a trans-acting regulatory RNA. Several pseudogenes of this gene have been identified. Alternative splicing results in multiple transcript variants. [provided by RefSeq, Jul 2013]
UniProt Code:	P35232
NCBI GenInfo Identifier:	464371
NCBI Gene ID:	5245
NCBI Accession:	P35232.1
UniProt Secondary Accession:	P35232,Q4VBQ0, B4DY47,
UniProt Related Accession:	P35232
Molecular Weight:	272
NCBI Full Name:	Prohibitin
NCBI Synonym Full Names:	prohibitin
NCBI Official Symbol:	PHB
NCBI Official Synonym Symbols:	PHB1; HEL-215; HEL-S-54e
NCBI Protein Information:	prohibitin; epididymis luminal protein 215; epididymis secretory sperm binding protein Li 54e
UniProt Protein Name:	Prohibitin
Protein Family:	Prohibitin
UniProt Gene Name:	PHB
UniProt Entry Name:	PHB_HUMAN

*Note: Protocols are specific to each batch/lot. For the correct instructions please follow the protocol included in your kit.

Before adding to wells, equilibrate the SABC working solution and TMB substrate for at least 30 min at 37°C. When diluting samples and reagents, they must be mixed completely and evenly. It is recommended to plot a standard curve for each test.

Step	Protocol
1.	Set standard, test sample and control (zero) wells on the pre-coated plate respectively, and then, record their positions. It is recommended to measure each standard and sample in duplicate. Wash plate 2 times before adding standard, sample and control (zero) wells!
2.	Aliquot 0.1ml standard solutions into the standard wells.
3.	Add 0.1 ml of Sample / Standard dilution buffer into the control (zero) well.
4.	Add 0.1 ml of properly diluted sample ( Human serum, plasma, tissue homogenates and other biological fluids.) into test sample wells.
5.	Seal the plate with a cover and incubate at 37 °C for 90 min.
6.	Remove the cover and discard the plate content, clap the plate on the absorbent filter papers or other absorbent material. Do NOT let the wells completely dry at any time. Wash plate X2.
7.	Add 0.1 ml of Biotin- detection antibody working solution into the above wells (standard, test sample & zero wells). Add the solution at the bottom of each well without touching the side wall.
8.	Seal the plate with a cover and incubate at 37°C for 60 min.
9.	Remove the cover, and wash plate 3 times with Wash buffer. Let wash buffer rest in wells for 1 min between each wash.
10.	Add 0.1 ml of SABC working solution into each well, cover the plate and incubate at 37°C for 30 min.
11.	Remove the cover and wash plate 5 times with Wash buffer, and each time let the wash buffer stay in the wells for 1-2 min.
12.	Add 90 Âµl of TMB substrate into each well, cover the plate and incubate at 37°C in dark within 10-20 min. (Note: This incubation time is for reference use only, the optimal time should be determined by end user.) And the shades of blue can be seen in the first 3-4 wells (with most concentrated standard solutions), the other wells show no obvious color.
13.	Add 50 Âµl of Stop solution into each well and mix thoroughly. The color changes into yellow immediately.
14.	Read the O.D. absorbance at 450 nm in a microplate reader immediately after adding the stop solution.

When carrying out an ELISA assay it is important to prepare your samples in order to achieve the best possible results. Below we have a list of procedures for the preparation of samples for different sample types.

Sample Type	Protocol
Serum	If using serum separator tubes, allow samples to clot for 30 minutes at room temperature. Centrifuge for 10 minutes at 1,000x g. Collect the serum fraction and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles. If serum separator tubes are not being used, allow samples to clot overnight at 2-8°C. Centrifuge for 10 minutes at 1,000x g. Remove serum and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles.
Plasma	Collect plasma using EDTA or heparin as an anticoagulant. Centrifuge samples at 4°C for 15 mins at 1000 × g within 30 mins of collection. Collect the plasma fraction and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles. Note: Over haemolysed samples are not suitable for use with this kit.
Urine & Cerebrospinal Fluid	Collect the urine (mid-stream) in a sterile container, centrifuge for 20 mins at 2000-3000 rpm. Remove supernatant and assay immediately. If any precipitation is detected, repeat the centrifugation step. A similar protocol can be used for cerebrospinal fluid.
Cell culture supernatant	Collect the cell culture media by pipette, followed by centrifugation at 4°C for 20 mins at 1500 rpm. Collect the clear supernatant and assay immediately.
Cell lysates	Solubilize cells in lysis buffer and allow to sit on ice for 30 minutes. Centrifuge tubes at 14,000 x g for 5 minutes to remove insoluble material. Aliquot the supernatant into a new tube and discard the remaining whole cell extract. Quantify total protein concentration using a total protein assay. Assay immediately or aliquot and store at ≤ -20 °C.
Tissue homogenates	The preparation of tissue homogenates will vary depending upon tissue type. Rinse tissue with 1X PBS to remove excess blood & homogenize in 20ml of 1X PBS (including protease inhibitors) and store overnight at ≤ -20°C. Two freeze-thaw cycles are required to break the cell membranes. To further disrupt the cell membranes you can sonicate the samples. Centrifuge homogenates for 5 mins at 5000xg. Remove the supernatant and assay immediately or aliquot and store at -20°C or -80°C.
Tissue lysates	Rinse tissue with PBS, cut into 1-2 mm pieces, and homogenize with a tissue homogenizer in PBS. Add an equal volume of RIPA buffer containing protease inhibitors and lyse tissues at room temperature for 30 minutes with gentle agitation. Centrifuge to remove debris. Quantify total protein concentration using a total protein assay. Assay immediately or aliquot and store at ≤ -20 °C.
Breast Milk	Collect milk samples and centrifuge at 10,000 x g for 60 min at 4°C. Aliquot the supernatant and assay. For long term use, store samples at -80°C. Minimize freeze/thaw cycles.

Tigatuzumab: Advancing Cancer Research with Targeted Therapies

Siltuximab: Exploring IL-6 Inhibition in Castleman’s Disease and Research

Sacituzumab: Exploring its Role in Cancer Research and the Rise of Biosimilars

Human Prohibitin / PHB1 ELISA Kit (HUFI02736)

Description