Human FGF9 ELISA Kit (HUFI00119)- High Sensitivity

Product Name:	Human FGF9 ELISA Kit
Product Code:	HUFI00119
Size:	96 Assays
Alias:	FGF9, Fibroblast Growth Factor 9, FGF-9, GAF, HBFG-9, HBGF-9, MGC119914, MGC119915, SYNS3
Detection method:	Sandwich ELISA, Double Antibody
Application:	This immunoassay kit allows for the in vitro quantitative determination of Human FGF9 concentrations in serum plasma and other biological fluids.
Sensitivity:	37.5pg/ml
Range:	62.5-4000pg/ml
Storage:	4°C for 6 months
Note:	For Research Use Only

Recovery:

Matrices listed below were spiked with certain level of Human FGF9 and the recovery rates were calculated by comparing the measured value to the expected amount of Human FGF9 in samples.

Matrix	Recovery range(%)	Average(%)
serum(n=5)	88-103	98
EDTA plasma(n=5)	86-102	95
UFH plasma(n=5)	89-103	95

Linearity:

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Human FGF9 and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample	1:2	1:4	1:8
serum(n=5)	85-103%	86-103%	90-104%
EDTA plasma(n=5)	86-99%	82-101%	83-100%
UFH plasma(n=5)	80-100%	80-100%	80-96%

CV(%):

Intra-Assay: CV<8%
Inter-Assay: CV<10%

Component	Quantity	Storage
ELISA Microplate (Dismountable)	8×12 strips	4°C for 6 months
Lyophilized Standard	2	4°C/-20°C
Sample/Standard Dilution Buffer	20ml	4°C
Biotin-labeled Antibody(Concentrated)	120ul	4°C (Protect from light)
Antibody Dilution Buffer	10ml	4°C
HRP-Streptavidin Conjugate(SABC)	120ul	4°C (Protect from light)
SABC Dilution Buffer	10ml	4°C
TMB Substrate	10ml	4°C (Protect from light)
Stop Solution	10ml	4°C
Wash Buffer(25X)	30ml	4°C
Plate Sealer	5	-

Other materials and equipment required:

Microplate reader with 450 nm wavelength filter
Multichannel Pipette, Pipette, microcentrifuge tubes and disposable pipette tips
Incubator
Deionized or distilled water
Absorbent paper
Buffer resevoir

Uniprot

P31371

UniProt Protein Function:	FGF9: Plays an important role in the regulation of embryonic development, cell proliferation, cell differentiation and cell migration. May have a role in glial cell growth and differentiation during development, gliosis during repair and regeneration of brain tissue after damage, differentiation and survival of neuronal cells, and growth stimulation of glial tumors. Defects in FGF9 are the cause of multiple synostoses syndrome type 3 (SYNS3). Multiple synostoses syndrome is an autosomal dominant condition characterized by progressive joint fusions of the fingers, wrists, ankles and cervical spine, characteristic facies and progressive conductive deafness. Belongs to the heparin-binding growth factors family.
UniProt Protein Details:	Protein type:Cytokine Chromosomal Location of Human Ortholog: 13q11-q12 Cellular Component: extracellular space; cytoplasm; extracellular region; basement membrane Molecular Function:heparin binding; growth factor activity; fibroblast growth factor receptor binding Biological Process: negative regulation of Wnt receptor signaling pathway; nerve growth factor receptor signaling pathway; embryonic skeletal development; negative regulation of transcription from RNA polymerase II promoter; signal transduction; positive regulation of vascular endothelial growth factor receptor signaling pathway; positive regulation of activin receptor signaling pathway; substantia nigra development; cell-cell signaling; positive regulation of MAPKKK cascade; protein import into nucleus; male sex determination; positive regulation of mesenchymal cell proliferation; positive regulation of cell proliferation; positive regulation of smoothened signaling pathway; chondrocyte differentiation; angiogenesis; regulation of timing of cell differentiation; embryonic gut development; positive regulation of cardiac muscle cell proliferation; embryonic limb morphogenesis; epidermal growth factor receptor signaling pathway; inner ear morphogenesis; fibroblast growth factor receptor signaling pathway; phosphoinositide-mediated signaling; male gonad development; osteoblast differentiation; positive regulation of cell division; insulin receptor signaling pathway; innate immune response; positive regulation of epithelial cell proliferation Disease: Multiple Synostoses Syndrome 3
NCBI Summary:	The protein encoded by this gene is a member of the fibroblast growth factor (FGF) family. FGF family members possess broad mitogenic and cell survival activities, and are involved in a variety of biological processes, including embryonic development, cell growth, morphogenesis, tissue repair, tumor growth and invasion. This protein was isolated as a secreted factor that exhibits a growth-stimulating effect on cultured glial cells. In nervous system, this protein is produced mainly by neurons and may be important for glial cell development. Expression of the mouse homolog of this gene was found to be dependent on Sonic hedgehog (Shh) signaling. Mice lacking the homolog gene displayed a male-to-female sex reversal phenotype, which suggested a role in testicular embryogenesis. [provided by RefSeq, Jul 2008]
UniProt Code:	P31371
NCBI GenInfo Identifier:	544290
NCBI Gene ID:	2254
NCBI Accession:	P31371.3
UniProt Secondary Accession:	P31371,Q3SY32, A8K427,
UniProt Related Accession:	P31371
Molecular Weight:	23,441 Da
NCBI Full Name:	Fibroblast growth factor 9
NCBI Synonym Full Names:	fibroblast growth factor 9
NCBI Official Symbol:	FGF9
NCBI Official Synonym Symbols:	GAF; FGF-9; SYNS3; HBFG-9; HBGF-9
NCBI Protein Information:	fibroblast growth factor 9; heparin-binding growth factor 9; fibroblast growth factor 9 (glia-activating factor)
UniProt Protein Name:	Fibroblast growth factor 9
UniProt Synonym Protein Names:	Glia-activating factor; GAF; Heparin-binding growth factor 9; HBGF-9
Protein Family:	Fibroblast growth factor
UniProt Gene Name:	FGF9
UniProt Entry Name:	FGF9_HUMAN

*Note: Protocols are specific to each batch/lot. For the correct instructions please follow the protocol included in your kit.

Before adding to wells, equilibrate the SABC working solution and TMB substrate for at least 30 min at 37°C. When diluting samples and reagents, they must be mixed completely and evenly. It is recommended to plot a standard curve for each test.

Step	Protocol
1.	Set standard, test sample and control (zero) wells on the pre-coated plate respectively, and then, record their positions. It is recommended to measure each standard and sample in duplicate. Wash plate 2 times before adding standard, sample and control (zero) wells!
2.	Aliquot 0.1ml standard solutions into the standard wells.
3.	Add 0.1 ml of Sample / Standard dilution buffer into the control (zero) well.
4.	Add 0.1 ml of properly diluted sample ( Human serum, plasma, tissue homogenates and other biological fluids.) into test sample wells.
5.	Seal the plate with a cover and incubate at 37 °C for 90 min.
6.	Remove the cover and discard the plate content, clap the plate on the absorbent filter papers or other absorbent material. Do NOT let the wells completely dry at any time. Wash plate X2.
7.	Add 0.1 ml of Biotin- detection antibody working solution into the above wells (standard, test sample & zero wells). Add the solution at the bottom of each well without touching the side wall.
8.	Seal the plate with a cover and incubate at 37°C for 60 min.
9.	Remove the cover, and wash plate 3 times with Wash buffer. Let wash buffer rest in wells for 1 min between each wash.
10.	Add 0.1 ml of SABC working solution into each well, cover the plate and incubate at 37°C for 30 min.
11.	Remove the cover and wash plate 5 times with Wash buffer, and each time let the wash buffer stay in the wells for 1-2 min.
12.	Add 90 µl of TMB substrate into each well, cover the plate and incubate at 37°C in dark within 10-20 min. (Note: This incubation time is for reference use only, the optimal time should be determined by end user.) And the shades of blue can be seen in the first 3-4 wells (with most concentrated standard solutions), the other wells show no obvious color.
13.	Add 50 µl of Stop solution into each well and mix thoroughly. The color changes into yellow immediately.
14.	Read the O.D. absorbance at 450 nm in a microplate reader immediately after adding the stop solution.

When carrying out an ELISA assay it is important to prepare your samples in order to achieve the best possible results. Below we have a list of procedures for the preparation of samples for different sample types.

Sample Type	Protocol
Serum	If using serum separator tubes, allow samples to clot for 30 minutes at room temperature. Centrifuge for 10 minutes at 1,000x g. Collect the serum fraction and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles. If serum separator tubes are not being used, allow samples to clot overnight at 2-8°C. Centrifuge for 10 minutes at 1,000x g. Remove serum and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles.
Plasma	Collect plasma using EDTA or heparin as an anticoagulant. Centrifuge samples at 4°C for 15 mins at 1000 × g within 30 mins of collection. Collect the plasma fraction and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles. Note: Over haemolysed samples are not suitable for use with this kit.
Urine & Cerebrospinal Fluid	Collect the urine (mid-stream) in a sterile container, centrifuge for 20 mins at 2000-3000 rpm. Remove supernatant and assay immediately. If any precipitation is detected, repeat the centrifugation step. A similar protocol can be used for cerebrospinal fluid.
Cell culture supernatant	Collect the cell culture media by pipette, followed by centrifugation at 4°C for 20 mins at 1500 rpm. Collect the clear supernatant and assay immediately.
Cell lysates	Solubilize cells in lysis buffer and allow to sit on ice for 30 minutes. Centrifuge tubes at 14,000 x g for 5 minutes to remove insoluble material. Aliquot the supernatant into a new tube and discard the remaining whole cell extract. Quantify total protein concentration using a total protein assay. Assay immediately or aliquot and store at ≤ -20 °C.
Tissue homogenates	The preparation of tissue homogenates will vary depending upon tissue type. Rinse tissue with 1X PBS to remove excess blood & homogenize in 20ml of 1X PBS (including protease inhibitors) and store overnight at ≤ -20°C. Two freeze-thaw cycles are required to break the cell membranes. To further disrupt the cell membranes you can sonicate the samples. Centrifuge homogenates for 5 mins at 5000xg. Remove the supernatant and assay immediately or aliquot and store at -20°C or -80°C.
Tissue lysates	Rinse tissue with PBS, cut into 1-2 mm pieces, and homogenize with a tissue homogenizer in PBS. Add an equal volume of RIPA buffer containing protease inhibitors and lyse tissues at room temperature for 30 minutes with gentle agitation. Centrifuge to remove debris. Quantify total protein concentration using a total protein assay. Assay immediately or aliquot and store at ≤ -20 °C.
Breast Milk	Collect milk samples and centrifuge at 10,000 x g for 60 min at 4°C. Aliquot the supernatant and assay. For long term use, store samples at -80°C. Minimize freeze/thaw cycles.

Clinical Pathology Labs List: Overview, Services, and Importance

Streptococcus pneumoniae: Pathogenesis, Diagnosis, and Treatment

Horseshoe Crab Blood and Endotoxin Testing: A Comprehensive Guide

Human FGF9 ELISA Kit (HUFI00119)

Description